Ps-audio Juice Bar User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
3
use a PS Audio xStream Power cable. To
provide the best electrical connection the
Juice Bar should be plugged into a PS Audio
Power Port duplex outlet.
Confirm that the blue indicator light is on.
This light indicates the presence of live AC
power. If the blue indicator light is not illumi
-
nating then there is no power present. Verify
the power source is active or the power
source is operational and providing power.
If the blue LED is lit, the connected equip
-
ment is ready to use.
Wall or ceiling mounting instructions
(Optional)
Two #8 or #10 screws are required. Make
sure the mounting surface is strong enough
to support the weight of the Juice Bar and
connected power cables, i.e., wood or ply
-
wood, etc. Alternatively, wall anchors can
be used if the surface is not supportive
enough.
Hold the unit in the desired mounting posi
-
tion. Mark the location of the screws with a
pencil. Pre-drill the holes at that location.
Insert the screws through the holes at each
end of the Juice Bar. While holding the Juice
Bar in place tighten the screws until they are
snug. Do not overtighten the screws.
Protection Features
Since The Juice Bar is designed for maxi-
mum performance and unrestricted current
flow it does not provide any protection as a
lightning arrestor, surge suppressor or spike
protector.
To properly protect connected equipment,
plug the Juice Bar into a product that pro
-
vides these features such as a PS Audio
Power Plant, Ultimate Outlet or any other
similarly designed device. This will not only
extend the number of available outlets but
extend the protection and cleansing benefits
as well.
If the Juice Bar is not plugged into a device
with these features the connected equip
-
ment is will not be protected.
Specifications
Height - 1.75 in
Width - 2.75 in
Length - 16.25 in
Weight - 3 lbs
Internal wiring - 14 ga
Power inlet - 15 amp IEC
Warranty and Service
Inside the U.S. and Canada
PS Audio’s warranty is 3 years parts and
labor, from the date of original purchase.
The warranty follows the product itself
regardless of ownership, new or used.
Outside the U.S. and Canada
PS Audio has authorized distribution in
many countries of the world. In each
country, the authorized importing retailer or
distributor has accepted the responsibility
for warranty of products sold by that retailer
or distributor. Warranty service should
normally be obtained from the importing
retailer or distributor from whom you
purchased the product. In the unlikely event
of service required beyond the capability
of the importer, PS Audio will fulfill the
conditions of the warranty. Such product
must be returned at the owner’s expense to
the PS Audio factory. Contact your PS Audio
distributor or the PS Audio customer service
department for more information.
Service issues
Should your unit ever require service or if
you have any technical questions about the
Juice Bar, ether contact your dealer (PS
Audio if purchased direct) or your PS Audio
distributor. No equipment will be received at
our service facilities without an attached RA
number.
If purchased through an authorized PS
Audio dealer or distributor, the RA number
must be obtained by the dealer or distributor.
If the product was purchased from PS
Audio direct, this can easily be obtained by
contacting PS Audio at:
Phone - 720.406.8946
Fax - 720.406.8967
Page view 2
1 2 3 4

Comments to this Manuals

No comments